5 Tips to Bring Down Operational Cost of Hot Water System

23:21:00 KW Homecare 0 Comments

During cold winter days, most of us feel lazy when it comes to taking a shower. The chilled environment prevents us from entering inside the bathroom. However, installing hot water system in the house will provide you with enough warmth during such days. It is true that hot water systems consume a lot of energy, and at times we have to bear the brunt of huge electricity bills. However, we can turn this inevitable baggage into a fruitful investment.  There are many simple ways through which you can bring down the cost of water heating; all you have to do is be a little alert, and you will surely be pleased with the results in the end.

install-hot-water-system

Here are The 5 Tips You Can Consider for Your Hot Water System

1. We often have this habit of turning on the hot water heating system even when using cold water. In the case of single handled faucet, most of us lift the handle at the center, which in turn draws in both hot and cold water. As a result, the water heater has to work even more. It is advisable to lift the handle on the side of cold water, and not at the center, if you want to use only cold water. In order to make the above mentioned tip more effective, you can install a dual handle faucet. In case of dual handle, the issue of crossover resulting from bad cartridge also goes away.

2. In order to save more, you have to change your behavior as well. Rather than taking long baths, it is better to take showers. Turning off the shower or reducing the speed helps in saving around 10 gallon of hot water each time. In this way, you will end up saving money.

3. The thermostat of your tank is set at a certain temperature, and if you bring down the level of temperature to 120 degrees, the hot water system will consume lesser amount of energy on daily basis. Remember, sometimes the thermostat may show you wrong readings; for this reason, rather than showing blind faith in the reading of the thermostat, you should check the temperature of the water coming out of the faucet, and adjust the thermostat accordingly. Mark the right spot on the thermostat.

4. With the passage of time, sediment accumulates inside the hot water tank, which in turn brings down the efficiency of the heating system. Cleaning the hot water tank is pretty easy; simply switch off the power line, and turn off the water connection. Take a garden hose and connect it to the base of the hot water tank. Once you carefully pull up the pressure relief valve while turning on the spigot of the tank, the sediment would come out though the hose.

5. Another way you can save money is by insulating the pipes. Simply insulate the water pipes through which hot water flows. It is an inexpensive method and will ensure your pipes last long and bring down your operational cost.

Apart from the tips mentioned above, there are many more effective ways to save money on your hot water system. If you try to bring down the consumption of water, it will prove to be quite effective in saving money in the long run. So, use the water heater smartly, and high energy bills would never bother you.

You Might Also Like

0 comments:

Note: only a member of this blog may post a comment.